Samsung DW80M3021 Serie Mode D'emploi page 15

Les langues disponibles

STEP 8 LEVELING THE DISHWASHER

1. Open the door and place the level against the top of the

tub on the inside and check if the the dishwasher is level.

If it is not level, rotate the leveling legs at the bottom front

of the dishwasher until the dishwasher is level.

See the ﬁ rst note below for instructions on adusting the

height of the front legs.

2. Use the level to check if the dishwasher is level front to

back, as shown in the ﬁ gure to the right.

If the dishwasher is not level front to back, adjust the

height of the rear leg until the dishwasher is level.

See the second note below for instructions on adusting

the the rear leg.

3. Open the door of the dishwasher and

check if both the tub and door clearances

are correct.

If not, rotate the leveling legs on the

bottom front of the dishwasher.

You can also check this by placing a level

against an inside front vertical surface of

the tub.

If the leveling legs are rotated to the right (counter

clockwise), they are loosened and the front of the

dishwasher is raised. If they are rotated to the left

(clockwise), they are tightened and the front of the

dishwasher is lowered.

To adjust the height of a rear leg, turn the Hexbolt (at

the front of the base) to the left to raise the back of the

dishwasher using the proper tool (Hex L-wrench or

similar tool).

Before you move the dishwasher for installation, make sure to adjust the height of the

legs so the legs are as short as possible. This prevents the legs from breaking. Level the

CAUTION

dishwasher by adjusting the height of the legs after you have the dishwasher in place.

The dishwasher can leak if it's tilted by more than 1 degree.

CAUTION

DW80M3021_DD81-02557A-00_EN.indd Sec3:15

installing the dishwasher _15

7/19/2017 4:54:39 PM