Publicité
Les langues disponibles
Les langues disponibles
Dial Position
Voltage AC
Voltage DC
Low Input
Lo-Z
Lo-Z
Impedance
Hz
Hz
Hertz
Resistance
Continuity
Capacitance
Current AC
Current DC
Temperature
Federal Communications Commission
Pursuant to part 15.21 of the FCC Rules, you
are cautioned that changes or modifications not ex-
pressly approved by the party responsible for compli-
ance could void your authority to operate the product.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules
and ISED-Canada's license exempt RSS standards.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference,
and 2) This device must accept any interference
received, including interference that may cause
undesired operation.
Range
600.0mV/6.000V
60.00V/600.0V
600.0mV/6.000V
60.00V/600.0V
600.0V
99.99/999.9Hz
9.999/50.00kHz
600.0Ω
6.000/60.00/600.0kΩ
6.000/40.00MΩ
Cont Buzzer
0-600.0Ω
100.0μF
1000μF
0.40mA-60.00mA/600.0mA
6.000A/10.00A
0.40mA-60.00mA/600.0mA
6.000A/10.00A
- 40.0ºC ~ 400.0ºC
†
-40.0ºF ~ 752.0ºF
FUNCTIONS
Resolution
0.1mV/0.001V/
0.01V/0.1V
0.1mV/0.001V/
0.01V/0.1V
0.1V
0.01Hz/0.1Hz/
0.001kHz/0.01kHz
0.1Ω
0.001/0.01/0.1kΩ
.001/.01MΩ
0.1μF
1μF
0.01mA/0.1mA
0.001A/0.01A
0.01mA/0.1mA
0.001A/0.01A
0.1°C
0.2°F
†Temperature Range, Resolution and Accuracy are
for the DMM. Temperature Probe may have different
specifications.
*These instruments are True-RMS sensing. All voltage
and current readings are True-RMS values.
*Input impedance:
Voltage DC: 10MΩ;
Voltage AC: 10MΩ // less than 100pF;
Lo-z: 4kΩ approximately
* Overload protection:
Voltage DC, Voltage AC, Lo-Z Voltage and Hertz:
AC/DC 720V for 10 second
Current DC & Current AC: AC/DC 20A for 10 sec.
Resistance, Continuity, Capacitance and Temperature:
AC/DC 600V for 10 second
* Maximum measurement time:
1 minute at 10A, rest time 20 minutes minimum
* Minimum frequency measurement is 2Hz
* Signal voltage in frequency mode: 8V-600V(RMS)
* Minimum AC Current measurement is 0.40mA
* Minimum AC Voltage measurement is 4.0mV
* For AC Voltage, AC Current and Lo-z:
Additional Accuracy by Crest Factor (C.F.):
Add 6.0% for C.F. 1.0 ~ 2.0.
Add 7.0% for C.F. 2.0 ~ 2.5.
Add 9.0% for C.F. 2.5 ~ 3.0
Max. Crest Factor: 1.6 for 6600 ~ 5000 digits
2.0 for 5000 ~ 3000 digits
3.0 for 3000 ~ 0 digits
* Measurement accuracy of square wave and truncated
waveforms at 1kHz is unspecified.
3
Accuracy
±(1.0% + 3 dgt) (45~500Hz)
±(2.0% + 3 dgt) (500~1000Hz)
±(0.5% + 2 dgt)
±(2.0% + 3 dgt) DC,AC : 45~500Hz
±(0.1% + 2 dgt)
±(1.0% + 5 dgt)
±(1.9% + 5 dgt)
Buzzer sounds at 30Ω or less
±(1.9% + 2 dgt)
±(1.5% + 3 dgt) (45~500Hz)
±(1.0% + 3 dgt)
±(1.0% + 10 dgt)
±(1.0% + 18 dgt)
Publicité
