Publicité
Les langues disponibles
Les langues disponibles
MONITOR DESCRIPTION
F
unction push buttons.
If the handset is on the craddle allows to see the picture from the master door panel.
If not, allows to establish audio and video communication with the door panel that has
been configurated with the autoswitch-on function. This function is disabled if a
communication is already established.
If the handset is on the craddle, press during 1 sec. to switch the monitor on or off. After
any monitor reset and during the next 45 seconds, all the monitor functions will be
disabled, with the exception of call reception.
With the handset lifted, allows to call to the master porter's exchange.
During call reception and communication progresses allows the lock release
activation, with no dependence on the handset position.
H
andling the end of line jumper.
The end of line jumper is placed on the CN2 connector, that can be located
on the monitor base.
In case of twisted pair cable installations, the end of line jumper is
placed in the EL562 module (see next paragraph).
Do not remove the jumper on monitors where the video cable finish.
Remove the jumper on monitors where the video cable continue.
Locate the CN2 connector, that's placed in the monitor base.
To plug the EL562 module, remove the existing jumper and the double
one (JP1) that's place on the right side.
NOTE: on this type of installations, the door panel must be setting with
SW1-3 configuration dip switch to ON; refer to the instructions manual
(T631/PLUS ML "page 115" or T500SE ML "page 116") that's enclosed
with the door panel.
Refer to the specific installation diagram.
23
E
L562 module for video installations
with twisted pair cable.
24
MONITOR CONNECTOR DESCRIPTION
a
b
50mm.
( ) *
50mm.
( ) *
Presionar para abrir.
Press to open.
CABLE
Max.
Max. pelado del cable.
Max. câble dénudé.
5mm
Max. peeled cable.
Max. aanstrip lengte.
8
4 2 9 8 9 8
0 1 1 8 7 5
CODE
11742180
REF
LOTE
RCTK
IMP903012
b
a
a. Wall attachment hole (x6).
b. Monitor attachment hook (x2).
c. Vertical wiring input.
d. Attachment clip.
e. Wiring input hole.
f. Installation terminals:
+, –:
positive, ground.
Vin / MP:
video signal coaxial input.
twisted pair video signal input (MP).
Malla:
coaxial shield.
Vo / VP :
video signal coaxial output.
twisted pair video signal input (VP).
A :
audio communication.
D :
digital communication.
HZ- :
door bell push button input.
D
escription of the RCTK monitor connector.
c
d
e
Colocar la parte superior de la regleta a 1,60m. del suelo.
Place the top part of the monitor connector at 1,60m.
from the floor.
( ) *
Distancia mínima entre los laterales de la regleta y
cualquier objeto debe ser de 5cm.
The minimum distance between the monitor connector
and the closest object must be 5 cm.
R5
UNO
V2PLUS
BUS
8
IN
7
Vi+
Vin
BUS
6
MP
MP
Malla
OUT
5
Shield
-
f
Vi
Vout
4
VP
VP
HZ
A/D
A
3
SA
D
PA
2
HZ-
PB
1
Publicité
