Publicité
Les langues disponibles
Les langues disponibles
Total vibration
Vibration emission value for sawing wood sheets (a
Vibration emission value for sawing sheet metal (a
Uncertainty (K)
5
Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
•
Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
•
Check the extension cord for damage at regular intervals.
•
Replace damaged extension cords.
•
When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
Information on recommended minimum conductor cross-sections and cable lengths is accessible via
a link, in the form of a QR code, at the end of this document.
6
Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Fitting the saw blade
1. Disconnect the supply cord plug from the power outlet.
2. Push the saw blade (teeth facing the cutting direction) into the blade holder until it engages.
3. Grip and pull the saw blade to check that it is held securely.
6.2
Fitting the guard
▶ Push the guard onto the product from the front until it clicks into place.
6.3
Fitting the suction adapter
1. Push the suction adapter onto the base plate horizontally from the rear until both catches engage at the
side.
2. Connect the vacuum cleaner hose to the suction adapter.
6.4
Setting the orbital action
1. Determine the correct orbital-action setting for the task to be performed with the applicable saw blade.
2. Set the orbital-action adjusting lever to one of the four settings → page 15.
6.5
Adjusting the stroke rate
Determine the correct setting for the task to be performed with the applicable saw blade.
*2150159*
2
3
4
5
6
2150159
)
h,B
)
h,M
SJT 6
12.1 m/s²
10.7 m/s²
1.5 m/s²
English
17
Publicité
