Power Dynamics PDX40 Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OVERVIEW
1. BT ANTENNA
The antenna receives and transmits the BT signal from a paired BT device.
2. STATUS LED
This LED indicates the unit's BT pairing status.
Light off: The unit is not paired to a BT compatible device. The unit is not able to make BT pairing in this state.
Light flashing: The unit can be paired to a BT device.
Light on: paired to BT device.
3. EXTERNAL PAIR BUTTON
Connection block for installing an external pair button.
4. PAIR
Press this button to make this unit available for pairing to a compatible BT device.
When paired, press this button to unpair.
5. OUTPUT VOLUME LEVEL
Rotate to adjust the output volume level (both balanced and unbalanced outputs).
6. POWER INPUT
Use the supplied power adapter to connect this input to a power outlet.
7. BALANCED OUTPUT
XLR output sockets. These outputs carry the signal from a paired BT device. Use XLR cables to connect these outputs to
your loudspeakers, mixer, etc.
8. UNBALANCED OUTPUT
6.3mm output jacks. These outputs carry the audio from a paired BT device. Use standard 6.3mm cables to connect these
outputs to your loudspeakers, mixer, etc.
OPERATION
Before transmission between your BT device and the PDX40 is possible, both devices must be coupled. This process is called
"pairing". The PDX40 is served as a receiver, to receive the music stream to be carried over. Once you "pair" your BT device
with the PDX40, they are "connected" wirelessly. You can play audio on your BT device, the signal will be carried over to the
PDX40 outputs (balanced and unbalanced).
NOTE: The PDX40 will not receive audio from a phone call. Recommended is to disable your cellular connection when using.
When a pairing has been successful, other BT devices cannot pair. To be able to pair another device, unpair ("disconnect") the
currently paired BT device.
If you have already coupled to a BT device before, this connection will be restored automatically when both devices are in range
and BT operation has been selected. "Pairing" does not have to be repeated. This function may need to be activated within your
BT devices' settings menu, however.
• Press the PAIR button to make a connection possible.
• Enter the BT settings menu on your BT streaming device, select PDX40 and initiate the pairing.
NOTE: If a PIN code is required, enter "0000".
When paired, press PAIR to unpair.
3