camry CR 4050 Mode D'emploi page 4

device (RCD) in the power circuit, with residual current rating not more than 30 mA. Contact
professional electrician in this matter.
15. Do not insert fingers or any other objects into blender's cup when the blender is on.
16. In order to avoid injuries handle the blades carefully.
17. Watch out for long hair, scarves, neckties hanging above the cup and operating
components of device.
18. For safety reasons use only original accessories and spare parts intended for particular
blender type, available at authorised service centre.
19. Handle the blades with extreme care while disassembling accessories. The blades can
cause cuts.
20. Do not wash any blender parts in dishwashers.
21. Change the accessories only when the device is switched off. Disconnect the device
from the power.
22. Do not put any products other than food and liquids in the blender cup. Do not put hot
products in the cup.
23. The device is not suitable for whipping egg whites or kneading dough.
24. Don't use aggressive detergents to clean the housing, as it may remove the
informational graphic symbols such as: scale, signs, safety marks, etc.
25. Do not start the empty mixing cup, without product inside.
26. MAXIMUM PERIOD OF CONTINUOUS BLENDER OPERATION IS 3 MINUTES. After 3
minutes of continuous operation stop the device and wait couple of minutes before
restarting.
27. Do not pour hot liquids (above 60 degrees Celsius) into the food processor.
28. If the blades are blocked, always disconnect the power cable plug from the power socket
before removing the blocking elements.
in the blender cup.
29. Do not move the appliance during operation.
DEVICE DESCRIPTION
1A – cup
1C – blender cup
1E – speed adjustment knob
1G – base of blender cup
2B – Off
2D – 2 speed
DEVICE OPERATION
Before first use:
1. Remove all stickers from the housing, cup and cover of the blender.
2. Wash the device according to part „Cleaning".
Blender operation:
1. Put the blender main body (1D) on stable, level surface.
2. Make sure the speed adjustment knob (1E) is set to the Off position (2B).
3. Place the blender cup (1C) on the body (1D).
4. Remove cover (1B) from the blender cup (1C), put in the ingredients to be mixed. In order to avoid overflow, the level of ingredients in
the cup should not exceed ¾ of cup's height.
5. Connect the power plug to the power outlet.
6. Turn the blender on by pressing Pulse button (2A) or by rotating speed adjustment knob (1E) to slower speed (2C) or faster speed (2D).
1B – cover
1D – body
1F, 2A – Pulse button
2C -1 speed
4