Husqvarna ST 124 Manuel D'utilisation page 19

Problem
Loss of traction drive/
slowing of drive speed
Loss of snow discharge or
slowing of snow discharge
Failure of auger rotation
after the grip is released
The lights are not on (if so
equipped)
The chute rotator is diffi-
cult to move
The product turns to one
side
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time.
• If the carburetor fuel bowl has a drain plug, empty
the fuel from the carburetor before you put the
product in storage for a long period of time.
1272 - 008 -
Possible cause
The belt slips.
The belt is worn.
The belt is off the pulley.
The chute deflector is clogged.
Foreign objects clog the augers.
The shear pin is broken.
Excessive snow and ice build up in between
track components.
The friction drive wheel is worn.
The drive belt is not aligned.
The discharge deflector is not aligned.
The engine is not running.
The wire connection is loose.
The LED is burnt out.
There is debris in the chute rotator mechanism.
The cables are kinked or damaged.
The tire pressure is not equal.
The product drives with only one wheel.
Uneven sled adjustment.
Uneven skid plates adjustment.
Transportation, storage and disposal
Adjust the cable. Adjust the belt.
Check / replace the belt.
Check / reinstall the belt.
Clean the chute deflector.
Remove the debris or the foreign ob-
ject from the augers.
Replace the broken shear pin.
Remove snow and ice build up from
in between track components.
Contact an authorized service center.
Adjust the drive belt.
Adjust the discharge deflector.
Start the engine.
Check the wire connections at the
engine and the lights.
Replace the LED light module. Indi-
vidual LEDs can not be replaced.
Clean the internal parts of the chute
rotator mechanism.
Make sure that the cables are not
kinked. Replace the cables that are
damaged.
Adjust the tire pressure and fill the
tire.
Inspect the tire lock pin.
Adjust the skid plates and the sledge.
Adjust the skid plates and the sledge.
• Safely attach the product during transportation to
prevent damage and accidents.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in a dry and frost free area.
Disposal
• Obey the local requirements and applicable
regulations.
• Discard all chemicals, for example engine oil or
fuel, at a service center or at an applicable disposal
location.
Solution
19