ASSEMBLY INSTRUCTIONS
Wall Hanging Installation
13. Using a stud fi nder, locate the edges of the wood
studs. Find the center line of each stud and draw a
vertical reference line on the wall over each one. Position
installation template (N) at desired location on wall.
Note: The bottom of the installation template (N) should
be no less than 31-1/2 in. from the fl oor.
Mark mounting holes with a pencil (not included) and
discard installation template (N). Drill 3/16 in. pilot holes at
marked locations. Then, with the beveled edge facing up,
attach the wall hanging cleats (M) with large fl at washers
(II) and lag bolts (HH).
Hardware Used
HH
Lag Bolt
II
Large Flat Washer
14. With the help from another person, carefully hang the
unit onto wall hanging cleats (M).
Shelf Installation
15. Insert shelf pins (GG) where desired in tower, then rest
adjustable shelf (G) on top. Repeat for second adjustable
shelf (G).
Note: Ensure the shelf pins (GG) are level.
Hardware Used
GG
Shelf Pin
Wooden Stud
13
16 in.
II
M
39-1/2 in.
N
II
M
Minimum 31-1/2 in.
x 4
14
x 4
M
M
M
15
x 8
Lowes.com/allenandroth
10
CARE AND MAINTENANCE
• Periodically check to make certain all components are properly positioned, free from damage and
fi rmly connected.
• Use a soft, clean cloth that will not scratch the surface when dusting.
• Never use water to clean the furniture as it may damage to the fi nish.
• Wipe clean using a damp cloth and a mild cleaner. Wipe dry with a clean cloth.
HH
• In the event the furniture is stained or otherwise damaged during use, it is recommended
you call a professional to repair the furniture.
• Keep furniture away from direct sunlight as it may damage the fi nish.
• It is best to keep the furniture in a climate-controlled environment. Extreme temperature and
humidity changes can cause fading, warping, shrinking and splitting of wood.
• Touch-up pen (MM) has been provided (except in Item #0339209) to repair any small nicks or
scratches that may occur during assembly or shipping. If Item #0339209 is damaged and touch-up
HH
is required, apply a quality wood polish to the damaged surface.
TROUBLESHOOTING
PROBLEM
Closet tower tilted.
GG
Closet tower can
G
not hang on the
wall.
GG
G
POSSIBLE CAUSE
Reinstall the wall hanging cleats and
The wall hanging cleats are not level.
ensure they are level.
Reinstall wall hanging cleats; make
sure the space between two wall
The mounting hole locations are not
hanging cleats is 39-1/2 in. and the
correct.
bottom two mounting holes location is
no less than 31-1/2 in. from the fl oor.
11
CORRECTIVE ACTION
Lowes.com/allenandroth