Power Dynamics PD810 Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
TRANSMITTER
1. Power On/Off
Press to turn the transmitter on/off.
2. LCD display
3. Up
Directional key: up.
4. Set
Press to confirm input.
5. Down
Directional key: down.
6. Input level
Rotate to adjust the input level.
7. Headphones output
6.35mm headphones output jack.
8. Headphones level
Rotate to adjust the headphone output volume.
9. 12V DC input
Power input for connecting the supplied power adapter.
10. Left channel input
Combo input for left channel (XLR and 6.3mm jack).
11. Right channel input
Combo input for right channel (XLR and 6.3mm jack).
12. PAD switch
Use to adjust output gain. To cut gain, set to (-12dB).To leave gain unaffected leave set the switch to (0dB).
13. BNC antenna connector
TRANSMITTER DISPLAY
1. Left / Right AF signal
2. Frequency
This six-character display is used to show the frequency.
3. Group
Displays the selected frequency group for the PD810 transmitter.
4. Channel
Displays the selected frequency channel for the PD810 transmitter.
5. Audio mode
Display the selection of mono- or stereo audio mode.
TRANSMITTER FUNCTION
Group and channel selection
Press SET, "GROUP" will flash. Press UP or DOWN to select the desired frequency group.
Press SET again, "CHANNEL" will flash. Press UP or DOWN to select the desired channel.
Mode selection
Press and hold SET, until "STEREO" will flash. Press UP or DOWN to select "STEREO" or "MONO", press SET to confirm.
3