Braun 750cc-7 Mode D'emploi page 18

All manuals and user guides at all-guides.com
Series
Ser ies
r e l e as e
Series 7
r e l e as e
click!
Series 7
r e l e as e
Series 7 Series 7
r e l e as e r e l e as e
Series 7 Series 7
r e l e as e r e l e as e
r e l e as e r e l e as e
new
old
18
Manual cleaning
Rinsing the shaving head under running water
is an alternative way to keep the shaver clean,
especially when travelling:
• Switch the shaver on (cordless) and rinse the
shaving head under hot running water.
You may use liquid soap without abrasive
substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, press the release
9
button to remove the Foil & Cutter cassette
8
and let it dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil on top of the Foil & Cutter
cassette.
Alternatively, you may clean the shaver with a
brush:
• Switch off the shaver. Remove the Foil &
Cutter cassette
surface. Using a brush, clean the inner area of
the pivoting head. However, do not clean the
cassette with the brush as this may damage it.
Cleaning the housing
From time to time clean the housing of the
shaver and the Clean&Renew station with a
damp cloth, especially inside the cleaning
chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button
housing, wait for a few seconds before removing
the used cartridge to avoid any dripping.
Before discarding the used cartridge, make sure
to close the openings using the lid of the new
cartridge, since the used cartridge will contain
contaminated cleaning solution.
Keeping your shaver in top shape
Replacing the Foil & Cutter cassette / reset
To maintain 100% shaving performance, re-
place the Foil & Cutter cassette
replacement symbol lights up on the shaver
z
display (after about 18 months) or when
cassette is worn.
8
and tap it out on a fl at
8
, when the
2
to open the