Publicité
Les langues disponibles
Les langues disponibles
To Dispense
Water:
1. Press a sturdy glass against the water dispenser lever.
2. Remove the glass to stop dispensing.
NOTE: Water may have an off-flavor if you do not use the
dispenser periodically. Dispense enough water every week to
maintain a fresh supply.
After changing the water filter, reset the status light by pressing
and holding the RESET button for 2 seconds. The status light will
change from Replace (red) to Good (green) when the system is
reset.
WATER
FILTER
GOOD •
O_RDER •
RESET
The Dispenser Light
The dispenser area has a light. It can be turned on manually by
pressing the ON button (touchpad or rocker switch).
On some models: Whenever you use the dispenser, the lever will
automatically turn the light on.
LIGHT
OFF
ON
NOTE: See the "Changing the Light Bulbs" section for
information
on changing the dispenser light bulb.
The Dispenser
Lock (on some
models)
The dispenser can be locked for easy cleaning or to prevent
unintentional
dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the
refrigerator, to the ice maker, or to the dispenser light. It simply
deactivates the dispenser levers.
To turn off the dispenser, press the LOCK button. The indicator
will appear above the LOCK button and the ice and water
dispensers will not work. To unlock the dispenser, press the
UNLOCK button until the indicator appears. Then continue to
dispense ice or water as usual.
DISPENSER
LOCK
UNLOCK
The water filter status light will help you know when to change
your water filter. When the status light changes from green to
2.
yellow, this tells you that it is almost time to change the water
filter. It is recommended
that you replace the filter when the
status light changes to red OR when water flow to your water
3.
dispenser or ice maker decreases noticeably. To change the filter,
see "Changing the Water Filter" later in this section.
INDICATOR:
STATUS:
GOOD (green)
New filter installed
ORDER (yellow)
Order filter
REPLACE (red) OR
Replace water filter
when water flow decreases
NOTE: Do not use with water that is microbiologically
unsafe
or of unknown
quality without
adequate
disinfection
before
or after the system.
Systems certified
for cyst reduction
may
be used on disinfected
waters
that may contain filterable
cysts.
Changing
the Water Filter
The water filter is located in the base grille below the freezer
compartment
door. It is not necessary to remove the base grille
to remove the filter.
1. Remove the filter by pressing the eject button and pulling
straight out on the filter cap.
NOTES:
•
Avoid twisting the cap when removing the filter because
this could cause the cap to come off. If this occurs,
replace the cap and pull the filter straight out.
•
There will be water in the filter. Some spilling may occur.
..............................
B
A. Eject button
B. Filter cap
Remove the cap by turning it counterclockwise
until it stops.
IMPORTANT:
Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
Take the new cartridge out of its packaging and remove the
protective cover from O-rings.
A. Protective cover
B. O-rings
12
Publicité
