Installation And Connection - Alto Professional AX2304 Guide D'utilisation

INSTALLATION AND CONNECTION

Read this section carefully. Not paying enough attention to the input signal's level, routing, or assignment of
can result in unwanted distortion, a corrupted signal or no sound at all.
Power Connection
Use the same fuse as marked on the fuse holder near the power jack. Connect AX2304 to a standard power
outlet using the enclosed power cable.
Audio Connection
AX2304 uses balanced XLR connectors. It can be connected to other units in a variety of ways to support a
vast range of applications without experiencing signal loss.
Wiring Configuration
XLR servo connectors can be wired in balanced and unbalanced modes. Please wire your systems
according to the following examples:
•
1/4" Phone jack
Tip
Sleeve
TS Type Unbalanced
•
XLR connector
Pin1
XLR Type Unbalanced
Ring
TRS Type Balanced
Pin2 (+)
Pin2 (+)
Pin3 (-) Pin3 (-)
(Linked to Pin1 manually
(Linked to Pin1 manually
Tip
Sleeve
Pin3 (-)
Pin3 (-)
XLR Type Balanced
4
Tip
Ring
Sleeve
TRS Type Unbalanced
Pin2 (+)
Pin1
Pin1