Publicité
WARNING:
CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD
VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY
WITH THE LIMITS FOR A CLASS B DIGITAL DEVICE, PURSUANT
TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED
TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL
INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT
GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY ENERGY
AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE
INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO
COMMUNICATIONS.
HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE WILL
NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT
DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION
RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE
EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY
TO CORRECT THE INTERFERENCE BY ONE OR MORE OF THE
FOLLOWING MEASURES:
•
INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND
RECEIVER.
•
CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT
DIFFERENT FROM THAT TO WHICH THE RECEIVER IS NEEDED.
•
CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV
TECHNICIAN FOR HELP.
CAUTION:
DO NOT SPLICE, REPAIR, OR MODIFY. UNPLUG WHEN NOT IN USE.
FULLY INSERT PLUG. DO NOT USE DAMAGED REMOTE SETS. INSPECT
PERIODICALLY. USE WITHIN THE ELECTRICAL RATING MARKED
ON THE REMOTE SET. DO NOT PLUG IN MORE THAN A TOTAL OF
1000 WATTS IN THIS REMOTE SET. IF WATTS ARE NOT MARKED ON
APPLIANCE, MULTIPLY AMPERE RATING (ON NAMEPLATE) BY 125
TO DETERMINE EQUIVALENT WATTS. ADD DETERMINED WATTS
FOR EACH PLUGGED-IN APPLIANCE OR LAMP (SUM OF WATTS
ON BULBS) TO FIND TOTAL WATTS BEING USED. OPERATING
TEMPERATURE RANGE 0°C (32°F) TO 45°C (113°F).
•
ONLY USE THE BATTERIES SPECIFIED AND BE SURE TO MATCH
THE + AND - POLARITY MARKINGS.
•
REMOVE EXHAUSTED OR DEAD BATTERIES FROM THE PRODUCT.
•
REMOVE BATTERIES IF PRODUCT IS NOT TO BE USED FOR A LONG
TIME.
Publicité
