Publicité
Step 13
å
Fasten the BOTTOMS (C) to the ENDS (A and B). Tighten
four TWIST-LOCK® FASTENERS.
å
Slide the BOTTOM MOLDINGS (J) onto the notched
edges of the BOTTOMS (C).
Slide the BOTTOM MOLDING (J)
onto the notched edge.
The groove
is closer to
this edge.
Page 18
J
S u r
f a c
e w
T W
i t h
I S T
- L O
F A S
C K
T E N
®
E R S
C
These surfaces
should be even.
How to use the SAUDER TWIST-LOCK® FASTENER
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
A
Notched edge
H
B
P
Notched edge
428729
Dowel end
The groove
is closer to
this edge.
J
C
i t h
e w
®
f a c
C K
S u r
- L O
I S T
E R S
T W
T E N
F A S
www.sauder.com/service
2
Publicité
