Snooze Function - Cresta DTX510 Mode D'emploi

INFORMATION:
•
The clock automatically changes from set-up mode to time mode if no keys are pressed
for 20 seconds.
•
The alarm sounds for 2 minutes if no key is pressed to stop it.

SNOOZE FUNCTION

To activate the snooze function, please follow the steps below
Press the key "SNOOZE/LIGHT ", while the alarm sounds, to activate the snooze function.
•
•
If the snooze function is
•
The alarm repeat after 5 minutes.
•
The snooze function can be stopped by pressing any key.
12/24 HOURS MODE
The time display can be in 12 (AM/PM）or 24 hours mode, please follow the manual set-up to
select
°C/°F TEMPERATURE DISPLAY
The temperature display can be in °C or °F, press "▼ " to select in normal mode
MAX./ MIN. FOR THE INDOOR/OUTDOOR TEMPERATURE AND HUMIDITY
Press " ▲ " to display indoor and outdoor max temperature and humidity,
•
Press " ▲ " again to display indoor and outdoor min temperature and humidity
•
Hold " ▲ " for more than 3 seconds to clear up the max./min.
•
TEMPERATURE ALERT SET-UP
"▼
•
" to flash ON OF ,press
Hold
Press "MODE ", the upper limit of outside temperature is flashing, use
•
set the maximum alert temperature.
Press "MODE ", the lower limit of outside temperature is flashing, use
•
set the minimum alert temperature.
If select OF, press "MODE " until to quit the alert.
•
•
When the alert is activated, the alert symbol will be shown.
.
TEMPERATURE ALERT ON/OFF
•
Alert on: Temperature alert symbol shown in display
•
Alert off: Temperature alert symbol goes out.
INFORMATION
•
The set-up process cannot be completed if the maximum temperature selected is lower
than the minimum selected temperature.
•
The minimum temperature selected must at least be 1°C below the maximum selected
temperature.
activated, alarm symbol is flashing.
" ▲" or " ▼"
.
to select on/ off
" ▲" " ▼"
to
and
" ▲" " ▼"
to
and