Bimar FD-80FR Notice D'instructions page 14

- Ventilation: the three speeds are selected by pressing the "SPEED" (3) button:
the symbol corresponding to the selected speed will light up: (1=min; 2= med;
3=max).
- Timer: sets the operating time at which the unit shuts down. Press the "TIMER"
(5), button repeatedly: each press changes the time in 1 hour intervals (from 1
hour to 8 hours), and the selected duration will be shown on the control panel.
To deactivate the timer, press the button until the timer turns off.
 Mode (2): the fan can work both at a constant speed (minimum, medium and
max), as well as at two different speeds that are intermittent:
"
Natural". To activate "Natural" mode, press the button until appears on the
display: speeds are random and cyclic (each cycle takes about 90 seconds).
To activate "Sleep" mode, press button once more until appears on the display:
this mode reduces ventilation speed from one speed to the lower speed every half
hour. The cycles are:
-
Maximum speed (3) set: the fan will run at maximum speed for 30 minutes,
then at medium speed for 30 minutes and then will switch to low speed until
the unit is turned off manually or by the timer which has been previously set.
-
Average speed (2) set: the fan runs at medium speed for 30 minutes, it
changes to minimum speed for 30 minutes and then turns off.
-
Minimum speed (1) set: the fan runs at minimum speed for 30 minutes, and
then turns off.
- Swing (right-left) : press the "SWING" (4) button, turn it on (symbol on,
turn it off (symbol off).
To operate the fan, plug it into a socket: the "
will hear a "beep" (indicating the standby status); press the "
activate the fan and select the desired functions.
To deactivate the unit, press the "
it from the socket.
CLEANING AND MAINTENANCE
Attention: before normal cleaning, remove the plug from the socket.
 Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive
products.
 Do not immerse any part of the fan in water or other liquid: if this should happen,
do not put your hand in the liquid, but first remove the plug from the socket.
" symbol will light up and you
" button and turn off the appliance, unplug
14/40
" " and
Sleep
) or
" button to