EcoNet UETST800SYS Guide D'utilisation page 14

Settings (con't)
Settings
80 80
Resume Schedule
75 75
Basic Time Humidity
Home Away
Vacation
Away Fan
65 72
BACK
Dehumidification
80
Enable Dehumidification? Yes
75
Dehumidify Set Point
52 %
Over-Cooling Amount
0 ºF
Dehumidify Drain Timer
5 min.
Home
72
BACK HUMIDIFICATION
Humidification
80 80
Enable Humidification? No
Resume Schedule
75 75
Humidify Set Point 30 %
Humidify During...
Heat
Smart Control
Off
Away
Home
Humidity With Fan
Off
72 65
BACK
> Return to Table of Contents
Humidity Settings (Menu > Settings > Humidity)
Control your home's humidity settings for more ideal comfort.
44% 44%
Installer
Dehumidification (Menu > Settings > Humidity)
Enable Dehumidification – The system will attempt to reduce humidity in
cooling mode by reducing fan speed and over-cooling the space (when allowed
44%
by the Over-Cooling setting). The system will only reduce airflow if the room
temperature is within one degree of set point, otherwise, full cooling airflow will
be performed.
Dehumidify Set Point – The indoor relative humidity to be controlled to while
in cooling mode.
Over-Cooling Amount – The system will activate cooling, and possibly over-
cool the space by the desired number of degrees to improve dehumidification
performance in an effort to reach the dehumidify set point. The factory setting for
over-cooling is zero (no over-cooling) and can be adjusted up to 5 degrees of
over-cooling.
Dehumidify Drain Timer – At the end of a cooling cycle, if set, the
continuous fan setting will be turned off for the selected amount of time in order to
drain water from the indoor coil.
Humidification (Menu > Settings > Humidity > Humidification)
Enable Humidification – The system can control a humidifier attached to the
furnace or air handler to increase humidity in the space. It is important to note you
44% 44%
cannot humidify above the dehumidification set point.
Humidification Set Point – This setting allows you to choose the indoor
relative humidity desired, under which humidification will activate. The default is
humidification set point is 30% and is configurable between 15 and 45%.
Humidify During – Select the modes in which humidification will be
performed. Humidification can occur during heating, continuous fan and/or
cooling mode.
• Heat – Humidifier will operate with equipment during Heat if a
humidification demand is present.
• Heat/Fan – Humidifier will operate with equipment during these modes if a
humidification demand is present.
• Heat/Fan/Cool – Humidifier will operate with equipment during these
modes if a humidification demand is present.
EcoNet Smart Thermostat User Guide
®
14