ECS Electronics AF-003-DB-N Instructions De Montage page 6

© ECS 2001 AF-003-DB-E
5. To connect the rear foglamps near the left rear light: see sketch 2 & 3.
A
Lights
fig. 2
*Yellow (Wire-kit)
6. In the left rear, in the C-pillar, there is an original wiring harness (see sketch 3).
In this harness there are several grey wires.
Search these grey wires for the rear foglamp signal using a testlight.
Cut this foglamp wire and connect it according sketch 2.
Put the 3-pole relay in the socket with the blue, red and yellow wires (see sketch 4).
7. Put the 8-pole connector (with the brown, red, and black wires) into module 5C002.
Mount this module to the left rear side using the double sided tape.
8. Lead the brown/white wire from the battery through the left side of the interior to the socket.
Insert the terminal of the brown/white wire into the supplied 3-pole connector
(The same position as the brown/white wire in the 3-pole connector of the harness).
Connect the 3-pole connectors.
Careful for sharp parts! Fit the eyelett to the + pole. Fit the fuse and cover to the fuseholder after
the socket has been connected. Put the relay with 15A fuse in the socket of the towbar harness.
Mount the relay-sockets using the double sided tapes to the left rear side.
9. Mount the socket to the towbar.
Reconnect the battery and check all electric functions, with trailer/caravan connected.
Reinstall disassembled parts.
200401I
C
B
*Red (Wire-kit)
Partno.: AF-003-DB
Switch
Fig. 3
Fig. 4
rev.0