ECS Electronics AF-003-DB-N Instructions De Montage page 5

1.
Remove the battery earth cable.
Remove the shelf and the carpet.
Remove the rear trim.
Put the seats in the forward position.
Remove the side trim.
Remove the rear lights.
2.
Drill a 17mm hole in the back of the boot just behind the socketplate.
Carefully remove all metal particles and treat the edges with anti-corrosion paint.
Put the rubber grommet in the hole.
3.
Lead the wiring harness in the boot.
Lead the end of the towbar wiring harness from the inside of the trunk through the grommet, to where the socket should be mounted.
Carefull: hot exhaust!
Pull the rubber coverplate over the end of the wiring harness.
Remove the contact holder from the socket and connect the socket as follows:
DIN/ISO 11446
1-8
STOP
Reverse
-
15 amp. +
30+
-
15 amp. +
15+
10
9
Mount the socket to the towbar.
4.
The other wires are connected with scotch-locks to the original wires near the rear light units (see sketch 1).
(Check the functions using a testlight).
COLOUR FUNCTION
Black/brown Right rear light
Blue/red Left brake light
Black/green Right direction indicator
Black/yellow Left direction indicator
Purple/black Left rear light
Black/Red Right reversing light
Mount the white wires on the left side in the rear of the vehicle to the original earthbolt.
© ECS 2001
FITTING INSTRUCTIONS ELECTRIC WIRINGKIT TOWBAR WITH 13-P SOCKET UP TO
DIN/ISO NORM 11446
ALFA 147 2000-
Partno.: AF-003-DB
D
1/L gelb jaune
2 blau bleu
3/31 weiß blanc
4/R grün vert
5/58-R
braun marron
6/54 rot rouge
7/58-L
schwarz noir
8 schwarz/rot noir/rouge
9
braun/weiß marron/blanc
10 rot rouge
11
weiß blanc
12 rot/blau rouge/bleu
13
weiß blanc
AF-003-DB-E
F GB NL
yellow geel
blue blauw
white wit
green groen
brown bruin
red rood
black zwart
black/red zwart/rood
bruin/wit
brown/white
red rood
wit
white
red/blue rood/blauw
wit
white
INFO
A
fig.1
200401I
B
A
rev.0