Tripp-Lite B118-002-HDR Manuel De L'utilisateur page 4

Installation
Note: The maximum distances referenced to in these instructions have been tested
using 28 AWG Premium High-Speed HDMI 3.0 cables at a 4K x 2K UHD video
resolution of 4096 x 2160 @ 60 Hz with 36-bit (12 bits per channel) Deep Color.
1. Make sure the power is turned off for all devices that will be connected.
2. Connect the HDMI source to the Input port on the splitter.
Notes:
• The B118-002-HDR-V2 uses a 6-inch (15.25 cm) pigtail HDMI connector.
• The length of the HDMI cable connecting the source to the splitter must not
exceed 15 ft. (4 m).
3. Connect an available Output port on the splitter to the HDMI Input port of
the display.
Note: The length of the HDMI cable connecting the source to the splitter must not
exceed 15 ft. (4 m).
4. Repeat step 3 for the splitter's remaining Output ports.
5. Connect the included power supply to the splitter, then plug it into a
Tripp Lite Surge Protector, Power Distribution Unit (PDU) or Uninterruptible
Power Supply (UPS).
Note: To power the B118-002-HDR-V2, use the included USB Micro-B cable to
connect the unit to a USB wall charger or USB port from the source.
6. Turn on the power to the HDMI source, splitter and displays.
19-04-006-933935.indb 4
4
5/7/2019 1:01:04 PM