G3 Ferrari ANTELAO G20142 Mode D'emploi page 12

OPERATING
STAINLESS STEEL IMMERSION SHAFT
- Assemble motor housing to the immersion stainless-steel shaft as described in the "Assembling the shaft"
section. Plug the unit to the electrical outlet.
- Insert the mixer in the bowl with the food to blend (ensure to immerse the entire blade to avoid any
splashing). Press the button (speed I or II) to start operating. For best results, follow the instructions in
"Setting processing speed" section.
CAUTION! Do not insert your fingers inside the bowl containing food
- Unplug the hand blender from the electrical outlet, once finished working,
This appliance is not suitable for chopping hard foods or ice. It is suitable for making baby food, milk shakes,
sauces, juices, cocktails, soups, vegetable soup, etc. ... When processing fruits or vegetables, add also a small
quantity of water to allow the device to operate in a homogeneous way.
Insert the motor body (4) in the shaft (6). Rotate clockwise until it blocks.
SETTING THE WORKING SPEED
The unit features two working speeds (2 and 3 button) and a speed controller (1).
The speed control allows to modulate the speed of blades or whisk, and it can be used only with the low
speed. The second speed is faster than the first one, even if you put the controller to the maximum level.
For best results and to avoid overheating, it is recommended to use the unit for short and regular intervals,
then for a long time, always making circular movements inside the container of food.
It is also recommended to start processing food from the first speed, then gradually increasing by using the
speed controller, ending up using the faster speed.
WHISK ATTACHMENT (ONLY FOR G20143)
- Assemble chopper set as described in the "Assembling the whisk" section.
- Plug the unit to the electrical outlet. Press the button (speed I or II) to start operating.
CAUTION: do not insert your fingers or hair inside the food container.
- Unplug the unit from the outlet once the process is finished.
The whisk attachment is ideal for creating sauces and cream and for whipping and whisking.
Insert the pin of the whisk (9) into the attachment (8).
Insert body (4) in attachment (8) and rotate clockwise until it blocks.
CHOPPER (ONLY FOR G20143)
Assemble chopper set as described in the "Assembling the chopper" section.
- Plug the unit to the electrical outlet. Press the button (speed I or II) to start operating.
CAUTION: if you lift the lid from the working bowl, the blade will stop automatically, avoiding any
risk of injury.
- Unplug the unit from the outlet once the process is finished.
This appliance is not suitable for chopping hard foods or ice, as they could damage the blades. Otherwise, it is
suitable for making baby food, milk shakes, sauces, vegetables, fruits, almonds, meat, etc... When processing
fruits or vegetables, remember to chop them into small pieces
and remove pits or hard rinds.
If you want to prepare baby food, add some water or milk in
small quantity.
Do not exceed the maximum capacity of the bowl.
Assembling the chopper set
Assemble the set as shown on Figure 3, 4 and 5.
Assemble the blades to the bowl as shown in Figure 3 and
insert the food.
Assembling the shaft
Assembling the whisk attachment
11