G3 Ferrari ANTELAO G20142 Mode D'emploi page 11

- Do not subject the product to strong impacts, serious
damages may result.
Do not use near or under flammable materials (like
curtains), heat, cold spots and steam.
GENERAL INSTRUCTIONS
The blades of the hand blender are very sharp to
chop: Be careful not to cut yourself during cleaning
operations and/or when removing the attachments.
To avoid the overheating of the motor, do not use the
appliance running continuously for more than 30 seconds,
then make at least 5 minutes rest. Do not use the product
without food. Do not insert your fingers inside the bowl
while the mixer is running.
Before using for the first time, carefully wash the parts
that will be in touch with food: immersion cone,
accessories and blades. Before operating the appliance,
check that all the parts are correctly installed.
Never leave the appliance unattended while it is running.
CAUTION! Unplug the unit from the socket
before touching the blades for any reason, such as
cleaning or foods removing.
CAUTION! Always unplug unit from the electrical outlet
each after use and/or before touching blades and/or before
installing or removing any accessory or attachment.
To clean the immersion cone and the accessories, it is
recommended using warm tap water and containing the
use of detergents. When gleaning with detergents, rinse
thoroughly. Do not immerse the top of the mixer in water
or other liquids, clean it with a damp cloth.
PARTS G20142 - G20143
1. Speed regulator
4. Motor body
7. Blades
9. Whisk (only for G20143)
11. Chopper bowl (only for G20143)
2. Switch low speed
5. Plastic beaker
3. Switch high speed
6. Stainless steel immersion shaft
8. Whisk attachment(only for G20143)
10. Chopper lid (only for G20143)
12. Chopper blades (only for G20143)
10