Kenmore 110.27755 Serie Guide De Démarrage Rapide page 6

Ultra Clean with Soak
Use this cycle for sturdy or heavily soiled loads. This cycle
includes a 5-minute soak to help improve cleaning.
• Approximate cycle time: 60 minutes.
Normal
Select this cycle for cottons and linens used regularly. The
fast-speed spin shortens drying time.
• Approximate cycle time: 40 minutes.
Permanent Press
Use this cycle to wash no-iron/permanent press fabrics. This
cycle provides an additional load-cooling spray rinse to
reduce wrinkling.
• Approximate cycle time: 30 minutes.
Delicate
This cycle combines slow-speed agitation and slow-speed spin
to gently clean garments while reducing wrinkles.
• Approximate cycle time: 25 minutes.
Handwash
Use this cycle for special care items. This cycle features a
series of brief agitation and short soaks for the gentlest
cleaning and for minimal wrinkling.
• Approximate cycle time: 25 minutes.
Soak
This cycle features agitation followed by unlimited soak time
to help remove stains that need pretreatment. After soaking,
you have two options. To use the same water in a wash
cycle, advance the Cycle Selector (Timer) Control knob to a
wash cycle. To remove the soak water, reset the washer to a
Spin setting. If the Soak water was drained, add more
detergent to the wash cycle.
}
%y_,_ Adjusting the soil level modifies the length of the wash
[ cycle. Based on the cycle and soil level selections, the
wash times will be extended or reduced anywhere from 1 to
8 minutes. Use the Heaw Soil selection for loads that need
a more thorough cleaning. Use the Regular Soil selection
for garments that are only lightly soiled or require a little
more care.
One Rinse
This is the rinse at the end of each cycle.
2nd Rinse
Choose this :ycle.
Prewash
This cycle helps to remove heaw soils that need pretreatment. This
cycle should be followed by a wash cycle. Add more detergent to the
wash cycle. The Prewash cycle does not include a rinse.
• Approximate cycle time: 12 minutes.
2nd Rinse
A second rinse can be used to aid in improved removal of detergent
or bleach residue from garments. This option may be automatically added
to the wash cycle by setting the OPTIONS control to 2nd
Rinse anytime before the end of the cycle.
Rinse & Spin
Select this option if you think an extra rinse is needed. Set OPTIONS
Control to 2nd Rinse. You should then set the Cycle Selector (Timer)
Control knob to a 2nd Rinse setting.
Spin Only
A drain and spin may help shorten drying times for some fabrics by
removing excess water. Set OPTIONS Control (if available) to One
Rinse. You should then set Cycle Selector (Timer) Control to a Spin
setting.
J
Before you call service...check for the following.
Loud clicking and banging?
• The yellow shipping strap may still be in the rear of the washer.
Completely remove the yellow shipping strap.
• The washer should be level, and the feet should be firmly on the
floor.
Some sounds are normal but may be different from those of
your previous washer.
• The gears engaging after the drain and before the spin.
• The sound of air being pulled through the pump after most of the
water has drained.
Is the washer leaking?
• Fill hose connections are tight
• Gaskets in fill hose are tight and flat
• Drain hose clamp is securely attached
• Faucets, drain/standpipe or laundry tub is not leaking
• The washer tub is centered, and the load evenly balanced
at the start of each load
• The washer is level
• The front feet are installed, and the nuts are tightened
to the cabinet
See the Use and Care Guide for complete details.
W10026582A
e; Registered Trademark / TM Trademark / SM Service Mark of 12/06
@ 2006 Sears Brands, LLC. Sears Brands, LLC, used under licensee by Sears Canada Inc. Printed in U.S.A