Publicité
Les langues disponibles
Les langues disponibles
en Before using for the first time
Before using for the first time
6 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
6.1 Setting an operating mode
Your appliance is set to air extraction mode by default.
Note: When using it in circulating-air mode, you require
additional accessories.
Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Basic operation
7 Basic operation
7.1 Switching on the appliance
Press
.
▶
a The appliance is activated for one minute.
7.2 Switching off the appliance
Press
twice.
▶
7.3 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
Press .
▶
a The appliance automatically switches off after ap-
prox. 6 minutes in the previous state.
7.4 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Cleaning and servicing
8 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
8.1 Cleaning products
You can obtain suitable cleaning products from after-
sales service or the online shop.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Do not use harsh or abrasive detergents.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
Wash sponge cloths thoroughly before use.
▶
20
Note: The saturation indicator for the grease filter is set
as standard. For use in the circulating-air mode, you
must also activate the saturation indicator for the odour
filter.
Requirement: The appliance is switched off.
Press and hold and
▶
lights up briefly first and then and
a
up at the same time.
a The saturation indicator for the odour filters is activ-
ated.
Press
.
▶
7.5 Switching off the lighting
Press
.
▶
7.6 Saturation indicator
The saturation indicator informs you about when the
grease filter has to be cleaned and when you have to
change the odour filter.
¡ If the grease filter has to be cleaned, flashes.
¡ If the odour filter needs to be replaced,
After cleaning the grease filter and/or changing the
odour filter, the saturation indicator should be reset.
Resetting the saturation indicator
Requirement: The appliance is switched on.
Press and hold
for 3 seconds.
▶
a The saturation indicator is reset.
or
stops flashing.
a
8.2 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are
not damaged by incorrect cleaning or unsuitable clean-
ing products.
WARNING ‒ Risk of explosion!
Highly caustic alkaline or highly acidic cleaning agents
in conjunction with aluminium parts in the interior of the
appliance may cause explosions.
Never use highly caustic alkaline or highly acidic
▶
cleaning agents. In particular, do not use commer-
cial or industrial cleaning agents in conjunction with
aluminium parts, e.g. grease filter on extractor
hoods.
for 3 seconds.
briefly light
flashes.
Publicité
