Maxvac MEDI 10 Manuel D'instructions page 5

INTRoDucTIoN
Dear Customer,
Thank you for choosing a Dustblocker,
made by MAXVAC.
All Dustblockers have been manufactured
with the greatest care and we hope that you
will be happy with the Dustblocker you have
just purchased.
However, if the Dustblocker does not fully
comply with your expectations please contact
your supplier.
These instructions are intended for MAXVAC
Dustblockers, model MEDI 10.
1. Duskblockers can only be used for
filteringdry, non-explosive air.
2. Dustblockers cannot be used in moist
rooms or rooms where an explosion hazard
may exist.
3. Only connect to 230V, check if this
matches your network. Do not use this
machine with 110V.
4. MAXVAC cannot be held liable if the
Dustblocker MEDI 10 is used for other
applications or if the Dustblocker MEDI 10 is
not used in accordance with this manual.
MEDI 10
GENERAL
When removing the packaging, please check
whether the Dustblocker has been damaged
during transport.
• Damaged cables that have been bent or
torn can be dangerous during use of the
device and must be replaced immiediately in
order to prevent personal injuries.
• In order to prevent personal injuries and
property damages you must place the device
on a sturdy base so the Dustblocker MEDI 10
cannot fall over.
• Make sure you keep fingers clear when
opening and closing the machine filter
housing with the plug disconnected.
• In order to prevent a risk of explosion, you
should not place the device in a room that
may contain explosive gasses.
• Switch the unit to the off position (0)
before removing the plug from the socket.
If the switch is on sparks may be generated
between the socket and the plug of the
device.
• Prior to performing maintenance, first
remove the plug from the socket in order to
pre -vent electrical shock.
• When replacing the filter or hepafilter (with
the plug disconnected !) it is possible that
dust is dispersed that can be dangerous for
people's health. Therefore, users should
wear safety glasses, safety gloves and a
respiration mask that comply with protection
class FFP3.
• Do not drill through or break open the
H13HEPA/Carbon filter.
• NEVER switch on the machine when a
filter housing is opened.
MAX-VAC.COM 5