Geemarc AMPLICALL20 Mode D'emploi page 9

Note: Do not use a rechargeable battery. Do not put the
used battery into the household rubbish, pay attention to
regulations regarding battery disposal.
The Pairing Procedure
1. Press and hold the Pairing/Test button until the unit
makes a beep sound, then release the Pairing/Test
button. The 1
mode has been entered.
2. Press and hold the Pairing/Test button again until the
st
1 LED flashes, then press and hold the remote
button at the same time until the strobe flasher flashes.
The unit makes a beep sound to confirm pairing has
been successful.
3. If the user wants to pair a 2
st
the 1 LED lights, press the Pairing/Test button once,
st
the 1 LED goes off and then the 2
user is then able to pair the 2
same procedure for the 3
4. Repeat the above, all 3 LEDS flashing together for the
th
4 remote pairing.
INSTALLATION
st
LED lights to indicate that the pairing
nd rd
and 3 remote, when
nd
LED lights. The
nd
remote. Repeat the
rd
remote.
8