Télécharger Imprimer la page

Craftsman CMCD721 Guide D'utilisation page 10

Perceuse à percussion sans balai

Publicité

Les langues disponibles

Les langues disponibles

English
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
 7 
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Proper Hand Position (Fig. C)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle 
 10 
and one hand on the battery.
Fig. C
10
Trigger Switch and Forward/Reverse
Button (Fig. D)
The drill is turned ON and OFF by pulling and releasing
the variable speed trigger switch
trigger is depressed, the higher the speed of the drill.
A forward/reverse control button
rotational direction of the tool and also serves as a lock
off button.
To select forward rotation, release the trigger switch and
depress the forward/reverse control button on the right
side of the tool.
To select reverse, depress the forward/reverse control
button on the left side of the tool.
The center position of the forward/reverse control
button locks the tool in the off position. When changing
the position of the control button, be sure the trigger
is released.
8
Speed Selector (Fig. E, F)
The speed selector feature of your drill allows you to shift
gears for greater versatility.
nOTE: Do not change gears when tool is running. If you are
having trouble changing gears, make sure that the speed
selector is either completely pushed forward or completely
pushed back.
Fig. E
. The farther the
1
determines the
2
Fig. F
Fig. D
1
2
To select low speed, high torque setting (position 1),
turn tool off and permit to stop. Slide speed selector
away from the chuck.
To select the high speed, low torque setting (position 2),
turn tool off and permit to stop. Slide speed selector
back toward the chuck.
4
4
4

Publicité

loading