Power Dynamics PDCS403A Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REAR PANEL
1. LED indicators
Power (illuminated when the power is on)
Signal (illuminated when a signal is registered at the audio
input)
Protect (illuminated when there is an unusual operating
condition that might damage the audio setup)
2. Crossover control (High pass filter)
A high-pass filter (HPF) is an electronic filter that cut off signals
with a frequency lower than 100 HZ or 150 HZ
3. Volume
Rotate to adjust the volume
4. Output
Balanced parallel XLR output
5. Input
Balanced combi input connector (XLR/jack 6,3 mm)
6. Power switch
Switch to turn the device on/off. Before switching the device on,
first check all connections and turn the volume control fully
down (counter clockwise)
7. Power input
Before connecting the power cord, check if the mains corresponds to the voltage indicated on the rating plate on the unit.
Connect the power cord only to a mains socket outlet with a protective earthing connection
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing
the fuse, unplug mains lead
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver
Step 2: Remove the old fuse from the fuse holder
Step 3: Install the new fuse in the fuse holder
Step 4: Replace the fuse holder in the housing
3