Pattfield Ergo Tools E-HKS 1500-L Mode D'emploi page 13

Anleitung E-HKS 1500 L_SPK7:_
3. Proper use
The hand-held circular saw is designed for sawing
straight cuts in wood, in materials similar to wood,
and in plastics.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Voltage 230 V ~ 50 Hz
Power rating
Idle speed
Cutting depth at 0°
Cutting depth at 45°
Saw blade 190 mm dia.
Saw blade mount 20 mm dia.
Saw blade thickness
Double isolation
Weight
Laser class
Laser wave length
Laser output
Laser power supply: 2 x 1.5V (button cell)
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 95,7 dB(A)
pA
K uncertainty
pA
L sound power level 106,7 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
14.01.2008 13:49 Uhr
Total vibration values determined in accordance with
EN 60745.
≤ 2,5 m/s
Vibration emission value a
h
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Setting the cutting depth (Figure 2)
Release the handle on the rear of the guard hood
for adjusting the cutting depth (4).
1500 W
Place the saw foot (6) flat on the surface of the
workpiece you wish to saw. Raise the saw until the
4800 rpm
saw blade is at the required cutting depth.
66 mm
Refasten the handle for adjusting the cutting depth
47 mm
(4). Check the handle is securely fastened.
5.2 Miter stop (Figure 3)
The preset standard angle between the saw foot
2.8 mm
(6) and saw blade (12) is 90°. You can adjust this
II /
angle to carry out angled cuts.
5.1 kg
Release the locking lever for miter setting (7) on
the front of the saw foot.
1
You can now adjust the cutting angle to around
650 nm
45°. Keep an eye on the cutting angle scale (9) as
≤ 1 mW
you do so.
Refasten the locking lever for miter setting (7).
Check the handle is securely fastened.
5.3 Extraction of dust and chips (Figure 1a)
Connect your circular saw to a suitable vacuum
cleaner with the dust extractor adaptor (11) Then
fit the dust extraction adaptor (11) into the
intended sawdust extraction outlet (23) on the
hand-held circular saw. You can then connect a
suitable vacuum cleaner to the dust extractor
3 dB
adaptor (11) (vacuum cleaner not supplied). This
will provide excellent dust extraction on the
workpiece. The benefits are that you will protect
3 dB
both the equipment and your own health. Your
work area will also be cleaner and safer.
Dust created when working may be dangerous.
Refer to the section entitled "Safety instructions".
Important! The vacuum cleaner you use for the
Seite 13
GB
2
13