CLEANING AND MAINTENANCE
• Always make sure the heater is turned off and unplugged before cleaning.
• DO NOT clean with abrasive chemicals, cleaning agents or solvents.
• Never immerse in water or allow water to drip into the motor housing.
Cleaning
• Turn the heater OFF, unplug and
wait for it to cool down.
• Wipe the surface with a soft,
slightly moist cloth to remove
any dirt or dust.
• Clean dust between the grills
with a vacuum cleaner or air
duster.
Storage
• When not in use for an extended
period of time, clean as instructed.
• Cover and store in a cool, dry
location with cord arranged away
from traffic areas to avoid
trip-over.
11
TROUBLESHOOTING
The troubleshooting guide addresses the most common problems.
If problems persist, feel free to contact the Customer Support via email:
contact@oraimo.com
PROBLEM
Error code P4 on display.
Error code FF on display.
Other error codes on display.
Heater does not start.
SOLUTION
Tip-over protection has been triggered.
Place the heater back on a flat, level
surface and remain upright before
turning it on again.
• When the ambient temperature is
above 122 °F , the heater will stop
heating with beeps and FF on display.
• Unplug and wait for the heater to cool
down before turning it on again.
• E1 - Temperature sensor open circuit.
• E6 - Motor not working or other error.
• When the error code appears, the
heater will stop working with beeps.
Unplug the heater and contact our
Customer Support for help.
• Check if the heater is properly
connected to a powered electrical
outlet and the voltage indicated is the
same as your local supply.
• Make sure the temperature you set is
higher than the ambient temperature.
• Make sure that the heater is placed
upright on a firm, level surface.
12