Publicité
Les langues disponibles
Les langues disponibles
Problems
The control panel
Check if the switch on the back of the unit is on the I (on) posi-
display does not turn
tion.
on
Make sure the device is electrically powered
The
room
You have to wait at least 6 hours for the temperature to stabilize.
temperature
is
Depending on your installation, the temperature you read may be
different from the
different from the one displayed on the unit (a variation of
one displayed on the
0.5° C is normal). In this case, refer to the «Expert Menu», chapter
device.
«Temp. calibration».
The device
Make sure you are in Comfort mode.
does not heat up.
If you are programming, check if you are within a Comfort period.
Make sure the circuit breakers in the system are turned on or the
load-shedding device (if you have one) has not turned off the unit.
Check the air temperature of the room: if it is too high, the device
will not heat up.
The device is heating
Make sure the device is not located near an air stream or
all the time.
the set temperature was not increased.
The device
Increase the temperature by pressing
does not heat up
If the temperature setting is at the maximum, check the following:
enough.
- Check if there is another type of heating in the room.
- Make sure your device is only heating the room (door closed).
- Have the device supply voltage checked.
- Make sure the power of your device is adapted to the size of
your room (we recommend an average of 100 W/m2 for a ceiling
height of 2.50 m or 40 W/m3).
The device
The electrical resistance heats up the fluid which gradually and
takes time to heat up
naturally circulates inside the unit
Due to the inertial properties of the fluid the surface tempera-
ture of the unit when first starting to heat up reaches an optimal
level only after a minimum of 15 minutes, depending on the room
temperature.
The surface of the
It is normal for the device to be hot when in use. The maximum
device is very hot.
surface temperature is limited according to the NF Electricity Per-
formance Standard. However, if you feel that your device is still
too hot, make sure the power is adapted to the size of your room
(we recommend 100W/m² for a ceiling height of 2,50m or 40W/
m3) and that the device is not placed near an air stream which
would affect its control mechanism.
Trouble Shooting
31
Check
.
.
EN
Publicité
