Blaupunkt BP-GIKLED06 Mode D'emploi page 4

BP-GIKLED06
5. Operation
1. Install the insect killer on a stable and non-slippery surface.
2. Connect the insect killer to the power source.
3. Disconnect from the power supply after use.
For best results, turn off other light sources and prevent from installing the appliance in the draught.
Safety Sensor
This insect killer is equipped with a safety sensor. The insect killer stops working automatically when the
collection tray is being taken out.
6. Troubleshooting
Appliance does not start
Appliance does not light
7. Care and Maintenance
Storage
Store the appliance and its accessories in a clean and dry area.
Cleaning
Caution – Risk of electroshock. Never touch the metal grid with your bare hands.
The cleaning frequency depends on the intensity of use. Check the tray of the device at least once a week.
Clean more often if necessary.
Before starting any cleaning or maintenance activities, unplug the appliance from its power source, wait for
5 minutes and let it cool down.
Wipe all exterior surfaces of the appliance clean with a soft cloth dampened with a soap and water solution. Do
not immerse or submerge any part of the appliance in water or any other liquid. Never use solvents or cleaning
agents containing petroleum (petrol, kerosene, oil), paint thinner, turpentine, alcohol, or ammonia.
BP-GIKLED06_new.indd 4
Problem
Power supply not connected well
On-off button not pressed
Collection tray not fully inserted into
Power supply not connected well
PCB board is damaged
4
Reason
Fully insert collection tray into
appliance
Light source cannot be replaced;
Light is damaged
PCB board cannot be replaced; scrap
Possible solution
Reconnect the power supply
Press the on-off button
appliance
Reconnect the power supply
scrap the appliance
the appliance
09/09/2019 12:08:48