Publicité
Les langues disponibles
Les langues disponibles
If a fixed connection is being used, fit the power line with an Omni polar circuit breaker with a contact
opening gap equal to or greater than 3 mm, in an easily accessible position close to the appliance. Ground
cable (yellow-green colour) shall not be interrupted with this breaker.
If a plug and socket connection is being used make sure that the plug and socket are compatible. Avoid use
of adapters and shunts as these could cause overheating and burns.
In the case of linear connection of several devices the device must be grounded in each other point for that
purpose, which is located on the back of device.
In any case, the cable must be positioned so that at no point temperature will not reach 50° of Celsius
degrees higher than the common surrounding.
After connecting the device to the electricity, the entire installation and operation of the device must be
tested
Before first use all protection foils must be removed.
Manufacturer reserves the right refuse any responsibility in case of damages caused by wrong
installation, by disobeying of above mentioned recommendations
7
Publicité
