Concept ZV2010 Mode D'emploi page 58

EN
D. Timer
Press the timer button (D) to select the desired humidification time. The desired time can
be set between 1-12 hours at intervals of 1 hour. When the timer function is active, the
indicator light (D) lights up. If the 12 hour setting is exceeded, the display shows "CO" - the
timer mode is switched off at that moment, the indicator light is off. If you press the timer
button (D) while the appliance is operating with the timer function on, the remaining
time will be displayed for approx. 5 seconds. In this interval, the humidification time can
be changed by pressing the timer button again.
E. Setting the humidity level
Press the humidity setting button (E) to select the desired humidity between
40%–75% (the indicator light will light up). The desired air humidity can be set at intervals
of 5%. If the humidity setting exceeds 75%, the display shows "CO" - the humidity setting
mode is switched off at that moment, the indicator light is off. If the humidity exceeds
the set value, the appliance stops. It starts again when the air humidity drops below the
set level.
F. Adjusting the steam intensity
Use the steam intensity adjustment button (F) to change between 3 intensities
(low, medium, high). When the appliance is switched on, medium steam intensity is
automatically set.
Note: Always use fresh, distilled or demineralised water to avoid any malfunction.
Adding essential oil
To add essential oil, press the aroma tray (7) to take it out. Add 1-3 drops of essential oil to the pad inside. Press the
aroma tray again to secure it to the appliance body.
58
ZV2010