Segway Ninebot KickScooter D18E Manuel Du Produit page 2

EN EN
1
Diagram
Handlebar
Bell
Brake Lever
Headlight
Quick-release Lever
Folding Mechanism
Safety Lock
Reflector
Front Fork
Front Fender
Hub Motor
01
Dashboard & Power Button
Electronic Throttle
Dashboard & Power Button
Snap Hook
Stem
Footboard
Drum Brake
Power Button:
Buckle
to turn on/off the headlight and the rear light, and press twice to switch between the speed modes.
Speedometer:
Rear Fender
Walk Mode:
D18E / D28E / D38E: The headlight and rear light keep flashing and can't be turned off.
* How to enable it in the Segway-Ninebot app: Tap the sidebar menu > Settings > Walk Mode.
Rear Light
Speed Mode:
& Reflector
Insurance
Plate Area
Error Notification:
Reflector
Temperature Warning:
* At this point, the vehicle cannot accelerate and may not be charged. Do not use until the temperature has reverted to the normal range.
Battery Compartment
Bluetooth:
Battery Level:
Kickstand
* The battery power is very low when the first battery bar is red. Please charge your KickScooter immediately.
Charge Port
Speedometer
Bluetooth
Headlight
Temperature Warning
Press the button to turn on; press and hold the button for 3 seconds to turn off. When the KickScooter is on, press the button
It displays the current speed of the scooter, as well as error codes.
Max. speed is 5 km/h (3.1 mph).
There are three modes. The top speed is as follows:
Model
D18E
Mode
ECO (Energy-saving mode) 15 km/h
D (Standard mode) 25 km/h
S (Sport mode) 25 km/h
It indicates that the scooter has detected an error.
It indicates that the battery temperature has reached 55°C (131°F) or is below 0°C (32°F).
It indicates that the scooter has been successfully connected to the mobile device.
The total battery level equals 5 bars.
Speed Mode
Walk Mode
Error Notification
Battery Level
Power Button
D28E D38E
15 km/h 15 km/h
25 km/h 25 km/h
25 km/h 25 km/h
EN EN
02