Casselin CVCSS100L Mode D'emploi page 7

Place the shelves on the slides at the desired height.
Connect the showcase to the power cable. Press the ON/OFF switch.
Adjust the thermostat using the adjustment knob.
Preheat the display case without water in the water tray and without dishes inside to prevent water
condensation on the windows when the dishes are placed in the display case.
The indicator in front of the window indicates the temperature reached.
Pour water into the water tray (approximately 0.6 Liter) and place the tray in the location provided for this
purpose.
The water tray is used to keep the humidity in the display case to prevent dishes from drying out (especially
pastries).
Be sure to check the water level in the tank; add more if necessary.
The filling is done at the front as well as at the back.
Place the dishes contained in suitable containers on the shelves of the display case.
At the end of use, press the switch and unplug the appliance.
REMARK
The appliance is equipped with a safety system in case of overheating. In the event of tripping, unplug the
appliance and allow it to cool. If this protection system activates regularly, it is essential to contact your
retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device. To do this, wait for the temperature to drop, press the Reset button.
WARNING
Never place dishes directly on the shelves.
When the showcase is in operation, some parts of the appliance become hot.
To avoid any risk of burns, do not touch hot surfaces with bare hands, wear protective gloves.
6. CLEANING AND MAINTENANCE
6.1 Safety instructions
Any maintenance, cleaning, repair of the appliance must be done with the appliance unplugged (isolated from
all electrical sources).
The use of caustic detergents and baking soda for cleaning is prohibited. Water must not get inside the
device.
Never immerse the appliance in water or any other liquid.
Use the Casselin brand products provided for this purpose.
WARNING
The device cannot be cleaned with a direct water jet (no pressurized water jet).
6.2 Daily maintenance
Unplug the device
Clean the device with warm water and a clean cloth after each use.
After cleaning, use a soft, dry cloth to polish and dry the device. All parts must be dried.
Store the device in a dry place.
6.3 Safety instructions for the maintenance of the device
Daily check that the power cord is not damaged. Never use the appliance when the cord is damaged. If the
cord has any faults, it must be replaced by a qualified technician.
In the event of a fault, contact your dealer.
Any maintenance or repair work should only be carried out by a professional.
EN