Publicité
Les langues disponibles
Les langues disponibles
Supplied Accessories
Owner's manual
(1EMN25720A)
Remote control
(NH001UD)
SOURCE
SLEEP
FREEZE
FORMAT
BACK
ECO
OK
MENU
INFO
SAP
VOL
CH
MUTE
1
2
3
4
5
6
7
8
9
0
.
PREV CH
Batteries
(AAA, 1.5V x 2)
•
If you need to replace these accessories, please refer
to the part No. with the illustrations and call our toll
free customer support line found on the cover of this
manual.
Note
•
If you lose the screws, please purchase M4× 20 Phillips head screws at your
local store.
Symbols Used in this Manual
The following is the description for the symbols used in
this manual. Description refers to:
: Digital TV operation
ATSC
: Analog / Cable TV operation
NTSC
•
If neither symbol appears, the operation is applicable to
both.
Quick Start
(
LC320EM1 : 1EMN 25724
LC260EM1 : 1EMN 26459
Registration card
(1EMN 24701)
Screw kit
for attaching the base
(
)
LC320EM1: 1ESA19881
LC260EM1: 1ESA23705
Attaching the Base
You must attach the base to the unit to have it as a table top
unit. Be sure the front and rear of the base match the proper
)
direction.
1
Spread a thick and soft
cloth over a table as
shown.
Place the main unit face
down onto it. Make sure
not to damage the screen.
At least 2 people are
required for this step.
2
Insert 2 hooks under the
bottom of the main unit
into base holes. (shown by
➀
arrow
), then move the
base in the direction as
shown by arrow
stops and the 4 mounting
holes are aligned. Make
sure not to put the AC
power cord between the
base and the unit.
3
Drive Phillips pan screws
into the 4 threaded holes
at the bottom of the base
until they are tight.
To remove the base from this unit
•
Unscrew the Phillips pan screws on step 3.
After the screws are removed, move the base in the opposite direction as
➁
shown by arrow
on step 2, then pull the base up toward the rear of the
unit. Be careful not to drop the base when you remove it.
Note
•
When attaching the base, ensure that all screws are tightly fastened. If the
base is not properly attached, it could cause the unit to fall, resulting in
injuries as well as damage to the unit.
•
Make sure to use a table which can support the weight of this unit and is
larger than this unit.
•
Make sure the table is in a stable location.
•
When attaching the base, ensure that FRONT
upward. If it's not upward, the 2 hooks don't fi t in the base.
Fixing the Unit on Your Furniture
Screw this unit on your furniture tightly using wood screws
(not supplied) in the 2 holes at the back of the base as shown.
•
Recommended screw dimension : 5.1 x 20 mm
rear of this unit
Note
•
When you remove this unit make sure to unscrew the wood screws from
your Wood Stand, Furniture and other wood item.
➁
➁
until it
➀
.
written on the base is
↑
English
r
5
EN
Publicité
