Publicité
Les langues disponibles
Les langues disponibles
8. Recommendations for a proper access to the model
Preliminary assembly
8.1
Install the drain connection R1 with relative gasket.
8.2
In models EVS and EVS-ED, connect electric heater R0 and the motors by breaking through one of the knockout entries;
use the rubber fairlead supplied to prevent damage to the cables.
8.3
In models EVS/B and EVS/B-ED, electric heater R0 and motors are already connected in junction box SD: use anyway
the knockout entries and the rubber fairleads for electrical connections.
8.4
Use screws B, washers C and grommets D as shown in the figure to close and fasten fan shroud L1.
Access
8.5
Remove the drain connection R1 so that the movement of the fan shroud L1 is not hindered.
8.6
Loosen the knurled screws A and unscrew the fixing screws B of the fan shroud L1.
8.7
Move fan shroud L1 to the position shown in the figure.
Reassembling
8.8
Bring fan shroud L1 into position, making sure that the L3 casing remains inside it, tighten knurled screws A and secure
it with screws B.
8.9
Reassemble the drain connection R1.
L1
=
Fan shroud
L3
=
Casing
R0
=
Heater
R1
=
Drain connection
Figure 4
25
www.modine.com
Publicité
