Publicité
Les langues disponibles
Les langues disponibles
instruction manual
PaRTS DEScRiPTioN
1. Detachable nozzle for sucking liquid
2. Detachable nozzle with brush
3. Dust compartment
4. Dust compartment release button
5. Charging light (LED)
6. On/off slide
7. Adapter
8. Charging station
9. Filter
8
7
2
1
4
dust buster
6
5
9
3
BEFoRE ThE FiRST uSE
•
Take the appliance and accessories out the box. Remove the
stickers, protective foil or plastic from the device.
Vacuum cleaner rating: 7.2V DC 250mA 45W
Adaptor model:
TDUB-63V09
Input:
230V~ 50Hz
Output:
9V DC 250mA
•
You can install the charger to the wall by using the supplied screws and
plugs. Place the device in the charger and plug the adapter into the wall
outlet. Load the device at least 16 hours before using it for the first time.
•
The charging light turns on to indicate that the device is in the charger and
the adapter into the wall outlet.
•
The charging light stays lit until the device is in the charger and the adapter
into the wall outlet.
•
The charging light indicates no information on the loading level of the built
batteries.
uSE
4
•
Press the power button forward to switch the device on.
•
Leave the adapter into the outlet, and place the vacuum cleaner after use
always back into the charger, even when the battery is still almost full.
•
This device comes with two accessories:
•
A brush suction foot to vulnerable surfaces clean.
•
A wiper fluid to be sucked.
•
When you suck liquids hold the device with the power nozzle down to
an angle of 30 degrees. The wiper blade should touch the surface to be
cleaned. Don't tilt the device to one side.
•
Stop collect liquid as the liquid level the designation has reached maximum
level.
•
Press the button next to the on/off switch to disconnect the dust container.
•
Empty the dust container every time the device is used to suck liquids and
make it dry after use.
Publicité
