14 www.electrolux.com
4. Replace the battery and reinstall the
inside cover and back cover.
Battery Type: RG15D/E-ELL
(Rated Voltage: 3VDC)
WARNING!
Please use the battery
appropriately
1. Chemical Burn Hazard. Keep batteries
away from children.
2. Be sure the batteries are inserted
properly.
7. OPERATING INSTRUCTIONS
Some of the following instructions
can only be used by using the
Control Panel.
7.1 Usage of the Control Panel
Heating mode (on some models)
In this mode the exhaust adaptor hose
MUST be used.
1. Press the "Modes" button until the
"Heat" indicator is lit.
2. Press the "−" & "+" Temp buttons
for desired setting.
3. Press the "fan speed" button for
desired fan speed.
4. Connected drain hose.
See 7.3 Drainage section.
Cooling mode
In this mode the exhaust adaptor hose
MUST be used.
3. Do not use batteries other than the
type specified.
4. Do not use old batteries with new
ones.
5. Do not dispose of batteries in fire.
Batteries may explode or leak.
6. The cells shall be disposed of properly,
including keeping them away from
children and even used cells may
cause injury.
7. To prevent damage, remove the
batteries when not being used for
a long time.
8. This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
1. Press the "Modes" button until the
"Cool" indicator lights.
2. Press the "−" & "+" Temp buttons
for desired setting.
3. Press the "Fan speed" button for
desired fan speed.
It is not necessary to use the
drainage hose in the "cool" mode.
Fan mode
In this mode there is no need to use the
exhaust hose or drainage hose.
1. Press the "Modes" button until the "Fan"
indicator is lit.
2. Press the "Fan speed" button to
choose the desired fan speed.
3. The fan will run at the selected speed
and the display will show the room
temperature.