Casanoov RANGER B150 Mode D'emploi page 10

EN
Installation of Extended End Motor Arms to Gates
USE BUBBLE LEVEL
Extended arm - 1 cm
K
D
!
Before installation: extend the motor arm to its maximum size and then retract it
inwards by approximately 1 cm.
Make sure that the height of the post support is exactly the same as that of the gate
support.
If you do not ensure the level is exact, the motor arm will bend, resulting in failure. In
addition, the gate's pushing or pulling force will be reduced, causing the motor to open
or close the gate with difficulty or not at all. Large differences in level will damage the
motor and the motor arm.
10