THOMSON TH3HYDRO Manuel D'utilisation page 8

USING THE APPLIANCE
1. Attach the nozzel to the appliance.
2. Open the water tank cap, fill the tank with water which
temperature should not exceed 40°C, then close the cap.
Or, remove the water tank from the appliance,
hold the tank upright, fill the tank
with water (temperature not exceed 40°C),
then attach the tank onto the appliance.
3. Repeatedly press the Mode button to select your desired mode.
 The corresponding mode indicator light will illuminate.
3 Different Modes
NORMAL
For normal cleaning.
4. Hold the appliance in an upright position with nozzle tip pointed toward your teeth.
5. Keep your mouth opened slightly so that the water can flow out.
6. Press the ON/OFF button to start irrigating.
 Direct the water jet flow at a 90-degree angle to the teeth and gums.
 Direct the water jet along the gum line with the nozzle tip at a 90-degree angle to the gum tissue.
 Clean between the teeth and around any braces, crowns or bridgework thoroughly.
7. Once irrigation is complete, press the ON/OFF button to turn off the appliance.
Note:
If you need to replace the nozzle, press the ON/OFF button to
turn off the appliance and then press the nozzel release button to
remove the nozzle. Then attach another nozzel to the appliance.
After using the appliance
1. Open the water tank cap and dispose of the remainingwater in the tank.
2. Press the ON/OFF button to turn on the appliance, and drain the remaining
water from inside the appliance.
3. Press the ON/OFF button again to turn off the appliance, and close the
water tank cap.
4. Wipe the appliance dry with a soft cloth.
To prevent the growth of bacteria, make sure there is no remaining water inside the
appliance. If you are not going to use the appliance for some time, wipe and dry the
appliance thoroughly before storing it.
SOFT
Massage & stimulate gums for
enhanced circulation.
EN-7
PULSE
Clean deep between teeth
and below the gum line.