Publicité
Les langues disponibles
Les langues disponibles
4. Cut off the line and remove the battery from the inner part.
PRODUCT OVERVIEW
Nozzle
release
button
ON/OFF button
Mode button
Mode/Charging
indicator lights
Charging port
cover
Note:
There may be some liquid remaining inside the main appliance (tank, water suction tube, etc.),
but this is remaining distilled water that was used for the performance (water flow) test, so there
are no health concerns.
CHARGING THE APPLIANCE
It takes about 4 hours to fully charge the appliance.
A full charge lasts for 30 to 50 minutes of use.
1. Remove the charging port cover.
2. Plug the supplied power adapter into the charging port.
3. Plug the adapter into the mains socket.
4. The CH indicator light will flash during charging and will go out when the
appliance is fully charged.
5. Attach the charging port cover back to the appliance.
Note:
If the CH indicator light flashes during or after an irrigating, recharge the battery.
Nozzle (x2)
EN-6
Water
suction
tube
Filter
Water tank
Water tank cap
Publicité
