Tabelle System Kommandos; Tabelle Fehlercodes; Tabelle Werkseinstellungen - Baumer 14 Série Notice D'utilisation

6.3

Tabelle System Kommandos

Restore factory setting 0X02
Teach-in position A 0X02
Teach-in position B 0X02
Transfer switching 0X02
positions
Save parameters 0X02
6.4

Tabelle Fehlercodes

Communication error
(Checksum, ...)
Length of written SPDU is wrong
Reading an unimplemented SPDU
Writing to an unimplemented SPDU
Reading Index 2
Writing to a read only SPDU
Writing an unimplemented System Command
Distance between two tought points too small
Written parameter out of defined range
6.5

Tabelle Werkseinstellungen

Switching points work
Nominal value
quality parameter
Output Delay Function
Output Delay Time
fr_BA_FNDx14_FHDx14_IO.doc
10.04.2013/hem
0X82 Restores all original factory settings of the sensor
0XA0 Teach-in of switching point A. The measured distance is written into the interim Teach in
position register.
0XA1 Teach-in of switching point A. The measured distance is written into the interim Teach in
position register.
0XA2 Transfer of the teach-in positions from the interim to the working register.
0XE0 Save all parameters in Flash memory
0x10 0x00 Communication error, No details
0x10 0x00 Communication error, No details
0x80 0x11 Device error, Index not available
0x80 0x11 Device error, Index not available
0x80 0x23 Device error, Access denied
0x80 0x23 Device error, Access denied
0x80 0x23 Device error, Access denied
0x80 0x40 Device error, Interfering parameter
0x80 0x30 Device error, Parameter value out of range
0X40 Switching point A: 50mm
Switching point B: 65535 (entspricht "Not valid")
0X65 7
0X71 0 = No delay
0X72 1 (ms)
13/14 Baumer Electric AG
Frauenfeld, Suisse