Assemblage Des Paramètres; Table Des Paramètres Général; Table Des Paramètres Usage - Baumer 14 Série Notice D'utilisation

6 Assemblage des paramètres
Table des paramètres général
6.1
General information on sensors
Vendor Name 0X10 18
Product Name 0X12 22
Product ID 0X13 8
Serial Number 0X15 4
Firmware Revision 0X17 8
Application Specific 0X18 8
Name
6.2 Table des paramètres usage
Teach-in and switching points
Switching points 0X40 4
work
Teach-in positions 0X41 4
interim
Sensor functions
Teach function 0X60 1
Nominal value 0X65 1
quality parameter
Quality parameter 0X66 1
Output functions
Output delay 0x71 1
function
Output delay time 0x72 2
fr_BA_FNDx14_FHDx14_IO.doc
10.04.2013/hem
String
String
String
String
String
-
Switching point A (HB, LB)
Switching point B (HB, LB)
Teach-in Position A (HB, LB)
Teach-in Position B (HB, LB)
0 = One point Teach-in
(Reference position)
2 = Two point Teach-in
(ON/OFF-position)
Byte 0 (Subindex 1)
0 = no delay
1 = on delay
2 = off delay
3 = minimum pulse
4 = single shot positive edge
5 = single shot negative edge
Byte 1...2, time in 1ms
12/14
ASCII R "Baumer Electric AG" for all sensors
ASCII R Corresponds
description
ASCII R Corresponds with Baumer article number
ASCII R Baumer P-Code
ASCII R Baumer Firmware Revision
- R/W 8 Byte at customer disposal
50...400 R/W Distance information on switching points,
calculated from the information on Teach-
in position interim
50...400, R Distance information on Teach-in position
65535
0,2 R/W Selection of Teach mode
1..8 R/W Provided the internal quality parameter
drops below this threshold the switching
output is set.
1..8 or 255 R
0...5 R/W Choose delay funciton
0...1000 R/W Delay time
with Baumer article
Baumer Electric AG
Frauenfeld, Suisse