Publicité
Les langues disponibles
Les langues disponibles
Drain facility
The recommended height of the standpipe is 39 in / 99 cm. The drain hose must be routed
through the drain hose clip to the standpipe. The standpipe must be large enough to accept the
outside diameter of the drain hose. The drain hose is attached to the washer at the factory.
Flooring
For best performance, you must install your washer on a solidly constructed floor. Wood floors
may need to be reinforced to minimize vibration and/or unbalanced load situations. Carpeting
and soft tile surfaces are contributing factors to vibration which can cause your washer to move
slightly during the spin cycle.
Never install your washer on a platform or weakly supported structure.
Location considerations
Do not install your washer in areas where water may freeze, since your washer will always retain
some water in its water valve, pump, and hose areas. Frozen water can damage the belts, the
pump, hoses, and other components.
Alcove or closet installation
MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS:
Sides – 1 in / 25 mm
Rear – 6 in / 152 mm
Gap between end of water valve and the wall
- Case 1. Assemble supply hose after installing : Over 3.9 in (10 cm).
- Case 2. Assemble supply hose before installing : Over 2.8 in (7cm).
If the washer and dryer are installed together, the closet front must have at least a 72 in² (465 cm²)
unobstructed air opening. Your washer alone does not require a specific air opening.
A
1 in.
27.0 in.
(2.5 cm)
(68.6 cm)
A. Recessed area
B. Side view - closet or confined area
F900A WASH_WA50F_USER MANUAL_DC68-03133H-03_EN.indd 13
1 in.
(2.5 cm)
27.0 in.
1 in.
(68.6 cm)
(2.5 cm)
Closet Front – 2 in / 51 mm
TOP - 21 in / 533 mm
B
21 in.
(53.3 cm)
2 in.
29.3 in.
(5.1 cm)
(74.4 cm)
installing your washer _13
Case 1. 3.9 in. (10 cm)
Case 2. 2.8 in. (7 cm)
6 in.
(15.2 cm)
2013-12-23 19:16:54
Publicité
