Operation - RedMax BCZ350S Manuel D'utilisation

8. Tighten the nut with the socket wrench. Hold the
shaft of the socket wrench near the blade guard.
Tighten in the opposite direction to how the cutting
attachment rotates. Tighten it to a torque of 35-50
Nm.
To attach the guard extension
CAUTION: Use the guard extension when
you use a trimmer head/plastic blade. Do
not use the guard extension when you use a
grass blade.
1. Put the guard extension in the groove of the cutting
attachment guard.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
12
2. Put the guard extension into position on the cutting
attachment guard with the 4 locking hooks.
To remove the guard extension
• Release the locking hooks with the spark plug
wrench.

Operation

• Make sure that there are no cracks at the bottom of
the grass blade teeth or by the center hole of the
blade. Replace the blade if it is damaged.
1289 - 002 -