Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
Use EXTREME CAUTION when handling the appliance. When taking out of
package, it is recommended to lay the box safely on its side. For the most
part, the HOT & COLD WATER TOP LOAD WATER COOLER is assembled. Once
unpacked and standing up right, the drip tray will need to be inserted.
Location Requirements:
1.
Install in the area where it is protected from the elements including direct sun.
2.
Install and use only on a hard, flat and level surface.
3.
Do NOT place the dispenser inside an enclosed space or cabinet.
4.
Position the dispenser no closer than 4 inches from the wall with at
least 4 inches clearance on the sides to permit free airflow.
5.
Service should only be performed by a certified technician.
WATER COOLERS
It is very easy to replace 3 or 5 gallon coolers (not included). NOTE:
Excessive weight hazard - It is recommended to use two or more people
to move and install bottles. Failure to do so can result in injury.
With reusable cap:
•
If your water bottle has a reusable cap on the end
with a plug, safely place the 3 or 5 gallon bottle
onto the bottle probe and the nozzle should fit
securely onto the base. Once secure, you will begin
to see water flowing from the bottle to the tank.
If there is no reusable cap:
1.
Stand with your feet shoulder-width apart and
bend down to grab the new water bottle.
2.
Lift the bottle up and slowly tip it to a 45-degree angle
to allow water to begin dripping into the cooler.
3.
Place the bottle into an upright position as the flow
of water into the cooler begins to increase, and then secure it onto
the base. Once secure, you will begin to see water flowing from the bottle to the tank.
HOW TO OPERATE
WARNING: This unit is intended for water dispensing only. Do NOT use
other liquids. Do NOT use for other purposes. Warranty is void if used
with any other liquids such as coffee, tea, juices, beer or wine.
This dispenser has been designed to use water bottles with a 3
or 5 gallon capacity. Do NOT use alternative bottles.
Initial Set Up
To avoid damage to the compressor, allow the unit to sit upright for at least
4 hours prior to operation. NOTE: Make sure that switches are ON. Each the
Hot and Cold switches are located in the back of the water cooler.
1.
Remove the tamper seal from bottle cap. Do not remove plastic cap.
6
Publicité
