Publicité
Les langues disponibles
Les langues disponibles
•
It can take up to six hours after setup to dispense coldest water.
•
Make sure back of the dispenser is at least 4 inches from a wall
and that air is free to flow on all four sides of dispenser.
WATER DISPENSER IS NOT HOT
•
Make sure cold switch is ON. Switch is located in the back of the water cooler.
•
It can take up to 30 minutes after setup to dispense hottest water. Each
time hot water is dispensed, it needs time to heat up again.
•
Make sure back of the dispenser is at least 4 inches from a wall
and that air is free to flow on all four sides of dispenser.
DISPENSER IS NOISY
•
Make sure that the dispenser is positioned on a level surface.
CLEANING & MAINTENANCE
General Cleaning
General cleaning should be performed as needed and only takes five minutes or less.
1.
Clean the cabinet surfaces using a soft cloth and warm, soapy water. Rinse.
2.
Wipe dust in the back of the water cooler to improve efficiency.
3.
Remove drip tray cover and hand wash. Take a cloth and warm,
soapy water to rinse the inside of the drip tray. Rinse.
4.
Reattach drip tray.
Cleaning Water Lines & Cold Reservoir
Cleaning the water lines and reservoirs is recommended to happen once every three
months. NOTE: Recommended to do before loading a new 3 or 5 gallon jug.
1.
Unplug power cord from outlet.
2.
Remove water cooler bottle.
3.
Remove the plastic water guard and clean
with warm, soapy water. Rinse.
4.
Fill stainless steel reservoir with a mixture of
water and bleach and let it sit for 30 minutes.
5.
Remove cleaning mixture by dispensing it
from both taps into a bowl or pitcher.
6.
Wipe inside of reservoir with a soft cloth and fill with water.
7.
Dispense water from both taps into a bowl or pitcher.
8.
Repeat rinsing cycle if chlorine taste persists.
9.
Install a new bottle of water and plug in the power cord into grounded outlet.
8
Publicité
