BOHELL AT36LI Mode D'emploi page 19

ADJUSTMENT OF THE HANDLE
- The handle of this appliance can be turned
easily to get to different places.
- To do it, press the handle release button (I) and
swivel the handle until it snaps into place.
- In order to reverse it, press the button again and
swivel the handle to the other side.
ROTATING DIRECTION
- This appliance can screw and unscrew. In order
to do that, press the selector to the side that fits
your desired function.
SCREWING TORQUE SETTINGS
- Turn the torque adjustment ring to the number
which matches your desired finishing.
- Note: 1 for less force and 16 for max force.
Place this ring to max position (
tivate the torque. Then it will act as a drilling
function.
USE:
- Turn the appliance on, by using the on/off
switch.
LIGHT FUNCTION:
- The appliance includes a light function, which il-
luminates the working area under the appliance.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance by releasing the on/off
switch.
- Clean the appliance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
SUPPLIES
- Supplies can be acquired from distributors and
authorised establishments (such as filters, etc. )
for your appliance model.
- These supplies are available in specialist shops.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If the connection to the mains has been dam-
aged, it must be replaced, take the appliance to
an authorised technical support service. Do not
attempt to disassemble or repair the appliance
by yourself in order to avoid a hazard.
SPECIFICATIONS:
Rated Voltage
Battery Capacity
No load speed
) to deac-
Ø max screw
Nº of torque settings
Reversible
Charging time
Weight
Acoustic pressure level
Acoustic power level
Vibration
- NB: These specifications are subject to change
without notice of purpose of improvement.
- NB: By virtue of the conditions of fabrication
of this product, the maximum used power can
differ from that specified.
- Measured sound level determined according EN
60745-1.
- The vibration emission level given in this infor-
mation sheet has been measured according
EN 60745-1 and may be used to compare one
tool with other. It may be used for a preliminary
assessment of exposure
- The vibration value during actual use of the
power tool can differ from the declared total val-
ue depending on the way in which tool is used
- It's necessary identify safety measures to pro-
tect the operator that are based on an estima-
tion of exposure in the actual conditions of use
(taking account of all parts of the operating cy-
cle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
3,6 V
1,3 A·h
180 rpm
6 mm
16 + 1
5 h
0,4 Kg
L = 58,1 dB (A)
PA
K = 3 dB
PA
L = 69,1 dB (A)
WA
K = 3 dB
WA
0,402 m/s
2